A DMARC record tells receivers what to do with mail that fails authentication. The result is short but easy to misread. This page shows how to check a DMARC record and what each line means for your mail.
Key facts:
- A DMARC record is a TXT record at
_dmarc.yourdomainthat starts withv=DMARC1(RFC 7489). - The
p=tag sets the policy tonone,quarantineorreject, andsp=sets a separate policy for subdomains (RFC 7489). - DMARC passes only when SPF or DKIM passes and the passing domain aligns with the From domain (RFC 7489).
- Per the BillionVerify DMARC Checker, the result is the raw record plus the policy, the subdomain policy and the pct value.
- Per the BillionVerify DMARC Checker, the lookup uses the exact domain you type and does not climb to a parent domain.
How to check a DMARC record
- Enter the domain in your From address, such as
example.com. Do not add_dmarc, because the tool adds it. - Run the check.
- Read the raw record, then the lines under it.
If the record prints but no policy lines follow, the p= tag is missing or empty. Fix the tag before anything else.
What the DMARC result tells you
Policy: none
The domain monitors but takes no action on failing mail. This is the right start. It is not protection, though, and a none policy without a rua= address collects no reports. Look for a rua= tag in the raw record.
Policy: quarantine or reject
Receivers are asked to treat failing mail as suspicious or to refuse it. Before you rely on either, confirm that every real sender passes SPF or DKIM with alignment. A forgotten sender will be hit by the policy.
Subdomain policy
With no sp= tag, subdomains follow p=. The tool says so with “inherited from p=”. A strict policy with a missing sp is therefore stricter than it looks if you mail from subdomains.
The pct line
It shows the share of failing mail the policy applies to, and 100 when the tag is absent. A value of 25 means a partial rollout. The rest of the failing mail is handled under the next lighter policy. Raise it in steps as reports stay clean.
No DMARC record found
The tool looked for _dmarc on exactly the name you entered. A subdomain with no record of its own shows this message, even when the parent domain has one. Receivers fall back to the parent, so check the parent before you decide that the subdomain is open.
What this check does not cover
It does not test alignment on a real message. It does not read your reports either. Pair it with the SPF and DKIM checks, because DMARC is only as good as those two.
The tool also says nothing about your list. DMARC can pass while mail bounces to addresses that do not exist. To find out if an address can receive mail, use the single-address checker on billionverify.com. It gives 20 free full checks per IP every 24 hours, no sign-up.
What to check next
If the domain has no record, build one with the DMARC generator and start at p=none. If you are already at reject and legitimate mail still disappears, look at the rest of your setup. Use the BillionVerify verifier to test whether one mailbox accepts mail. That separates a dead address from a policy problem.